Garage Door Spring Replacement Cost in Garland, TX
A bang from the garage, a door that suddenly feels like it weighs a ton, or a visible gap in the coil above the door usually points to a broken spring. The next question is the price. This guide covers the published ranges for garage door spring replacement, what tends to push a quote up or down for homes in Garland, Texas, and what to ask before anyone starts work. For every other repair type, see the garage door repair cost guide for Garland, TX.
Garland Garage Door Experts is a free quote service, not a garage door company. We don't repair doors or set prices. Independent local garage door companies reply to requests and quote their own prices.
How much does garage door spring replacement cost?
Two widely used national cost guides put a spring replacement, parts and labor, somewhere between about $120 and $540. Fixr splits its figures by spring type. This Old House gives one higher range. Neither is a Garland price list, and no reliable Dallas-area price source was found, so treat these as planning numbers.
| Item | Typical range | Source |
|---|---|---|
| Extension spring replacement | $120–$250 | Fixr, Jan 2025 |
| Torsion spring replacement | $200–$350 | Fixr, Jan 2025 |
| Spring replacement (second guide) | $300–$540 | This Old House, Mar 2026 |
| Cable repair (if a cable is damaged too) | $100–$200 · $170–$320 | Fixr, Jan 2025 · This Old House, Mar 2026 |
| Service call / trip fee | $50–$75 | Fixr, Jan 2025 |
| After-hours or emergency surcharge | +$100–$300 | Fixr, Jan 2025 |
Read the table as a spread of likely outcomes. A quote near the bottom usually means one standard extension spring on a light single door during normal hours. A quote near the top usually means a pair of torsion springs on a heavy double door, sometimes with cables or rollers replaced at the same visit.
What moves a spring quote up or down
- Spring type. Torsion springs sit on a bar above the door. Extension springs run alongside the horizontal tracks. Both guides show torsion jobs costing more. If you're not sure which you have, the torsion vs extension springs post shows how to tell from the floor.
- One spring or two. Many doors use a pair. The spring that didn't break has done the same number of cycles, so many technicians suggest replacing both to keep the door balanced. Ask for the price of one and of two.
- Door size and weight. A 16×7 double door needs more lifting force than an 8×7 single. Insulated doors and doors with windows weigh more again. The spring has to match the door, which is why a technician typically weighs or measures before choosing parts.
- Cycle rating. Standard springs are commonly rated around 10,000 open-close cycles. Some companies offer higher-cycle springs for more money. Ask what rating you're getting.
- Related parts. Cables, drums, bearings and rollers work with the springs. Replacing a frayed cable during the same visit can be reasonable, but each part should be listed separately.
- Timing. Evening, weekend and emergency visits often carry a surcharge (Fixr: +$100–$300). If the door is closed and no car is trapped, a weekday visit may cost less.
- Trip or diagnostic fee. Fixr puts a typical service call at $50–$75. Some companies roll it into the repair and some charge it separately. Ask when you first call.
Why spring calls are common in Garland
Garland's housing is older than most of the Dallas–Fort Worth area. The city's median home was built in 1978, compared with 1992 for Texas, and 54.8% of homes were built before 1980 (American Community Survey 2020–2024). In parts of south and west Garland, ZIPs 75041 and 75042, the median build year is 1965 to 1968. Many of those doors have been through several sets of springs, and some still carry older hardware.
Use matters as much as age. Fixr's spring table shows a 10,000-cycle spring lasting roughly 13 to 14 years at two cycles a day, 9 to 10 years at three, and 5 to 6 years at five. A household that uses the garage as its front door can wear through springs much faster than one that parks in the driveway.
Summer is part of the picture too. DFW averages about 106 days a year at 90°F or hotter (NOAA 1991–2020 normals, DFW Airport). That doesn't mean heat breaks springs. It does mean springs, openers and seals in Garland-area garages work through long hot stretches, and the door industry's own guidance notes that rust and poor lubrication shorten spring life.
Can you replace a garage door spring yourself to save money?
Parts alone cost far less than an installed spring, which is why the question comes up. The difference in price covers sizing the spring to the door, the right tools, and the risk of something going wrong while the spring is under tension.
Safety first: Torsion springs store enough energy to cause serious injury. Leave spring and cable work to a trained technician. If a spring has broken, stop using the opener and don't try to force a heavy door up by hand. If the door is fully closed, leave it closed and call for help. If it's stuck open or partway, keep people, pets and cars out of the opening.
This site doesn't publish spring or cable instructions. If your car is stuck inside, the emergency garage door repair page covers safe next steps.
Know your rights before work starts
Texas consumer tip (not legal advice): Texas's Deceptive Trade Practices Act prohibits false statements about the need for parts or repairs, and claiming work was done when it wasn't (Bus. & Com. Code §17.46(b)(13), (22)). Ask for a written estimate and an itemized invoice that lists the parts replaced, and ask for your old parts back.
Texas doesn't issue a state license for garage door companies (TDLR's licensing programs don't include one), so a license number isn't something to look for. Ask any company for proof of liability insurance instead. Be cautious with ads promising very low service-call fees, listings with no local address, unmarked vehicles, look-alike company names, or requests for large upfront cash deposits.
Questions to ask when you compare spring quotes
- Is the price for one spring or two, and which type?
- What cycle rating do the new springs carry, and what does a higher rating cost?
- Is the trip or diagnostic fee included or separate?
- Are cables, rollers or other parts included, and is each one listed?
- Is there an after-hours charge for the time you want?
- What warranty terms apply to parts and labor, and can you have them in writing?
- Can you keep the old springs?
Repair the spring or replace the door?
A broken spring alone is rarely a reason to replace a door. A spring job usually runs a few hundred dollars, while Fixr puts a new single steel door, installed, at $700–$2,000 and a double door at $1,175–$4,075. Replacement starts to make sense when other problems stack up: cracked or hail-dented sections, a door that stays out of balance after new springs, or a style change you wanted anyway. The new garage door installation page covers sizes, insulation and HOA notes.
To get prices for your own door, describe the problem once through the free quote form or call (877) 265-2390. Independent local companies can reply with quotes, and there's no obligation. The garage door spring repair page explains what a technician typically does on a spring visit.
Frequently asked questions
How much does garage door spring replacement cost in Garland, TX?
Published national guides put it at about $120–$250 for extension springs and $200–$350 for torsion springs (Fixr, Jan 2025), or $300–$540 (This Old House, Mar 2026). These are estimates, not quotes. Garland-area companies set their own prices.
Should both springs be replaced at the same time?
On doors with two springs, many technicians recommend replacing both, because the other spring has done the same number of cycles and a matched pair keeps the door balanced. Ask for the price of one and of two so you can decide.
Is there a separate fee just for the visit?
Often. Fixr puts a typical service call or trip fee at $50–$75, and after-hours visits can add $100–$300. Ask about both before anyone comes out, and ask for the total in writing.
Can I open my garage door with a broken spring?
It's safer not to. With a broken spring the door is much heavier than usual and can drop. If it's closed, leave it closed and call. If your car is stuck inside, mention that when you request quotes.